LS Bodenschutz und Rekultivierung
Following surface disturbance, quaternary sands are the basic substrate for soil development in the Lusatian reclamation area. These substrates mostly contain few organic matter and, hence, are nutrient poor. Accumulation of soil carbon is an important factor for ecosystem development, where biological soil crusts initially influence soil processes and promote ecosystem succession. The compositional structures of biological soil crusts at various developmental stages and their photosynthetic properties were investigated on two former open-cast lignite sites, currently under reclamation, an artificial sand dune in Welzow Süd, and a forest plantation in Schlabendorf Süd (Brandenburg, Germany). As development of biological soil crusts progressed, their contents of organic carbon and total chlorophyll increased. The ratio of these parameters, however, varied with the relative contribution of lichens and mosses in particular. Also maximum photochemical efficiency, net photosynthesis and respiration increased with crustal development. An additional evaluation of NDVI and chlorophyll fluorescence images showed that especially moss-dominated biocrusts had higher photosynthetic capacity compared to green algae-dominated biocrusts or soil lichens, so the photosynthetic capacity showed to be highly species-specific. The ratio of gross photosynthesis to respiration indicated a higher ecological efficiency of biocrusts dominated by green algae than of lichen-dominated biocrusts. The occurrence of soil lichens reduced net CO2 fixation and increased CO2 release due to the enhanced mycobiontic respiration. During crustal succession, the rise of photosynthesis-related parameters is not necessarily linear as a result of the highly heterogenic distribution of the different crustal organisms between biocrusts of similar developmental stages as well as between those growing at the two study sites. Therefore, the evaluation of relevant ecophysiological parameters highlighted that not all biocrust-forming organisms similarly contribute to the ecophysiological behavior of biological soil crusts. Nevertheless, the occurrence of the biological soil crusts promoted soil formation and accumulation of soil carbon in initial soils.
Investigations were done on two former open-cast lignite mining sites under reclamation, an artificial sand dune in Welzow Süd, and a forest plantation in Schlabendorf Süd (Brandenburg, Germany). The aim was to associate the topsoil hydrological characteristics of green algae dominated as well as moss and soil lichen dominated biological soil crusts during crustal succession with their water retention and the repellency index on sandy soils under temperate cli-mate and different reliefs.
The investigation of the repellency index showed on the one hand an increase due to the cross-linking of sand parti-cles by green algae which resulted in clogging of pores. On the other hand, the occurrence of moss plants led to a de-crease of the repellency index due to absorption caused by bryophytes. The determination of the water retention curves showed an increase of the water holding capacity, especially in conjunction with the growth of green algae layer. The pore-related van Genuchten parameter indicate a clay-like behaviour of the developed soil crusts. Because of the inho-mogeneous distribution of lichens and mosses as well as the varying thickness of green algae layers, the water retention differed between the study sites and between samples of similar developmental stages. However, similar tendencies of water retention and water repellency related to the soil crust formation were observed.
Biological soil crusts should be considered after disturbances in the context of reclamation measures, because the ini-tial development of green algae biocrusts lead to an increasing repellency index, while the occurrence of mosses and a gain in organic matter enhance the water holding capacity. Thus, the succession of biocrusts and their small-scale succes-sion promote the development of soil and ecosystem.
Formation of soil lichen crusts at reclaimed post-mining sites, Lower Lusatia, North-east Germany
(2015)
Biological soil crusts were investigated at reclaimed post-mining sites near Welzow and Schlabendorf in
Lower Lusatia (Brandenburg, Germany). Various development stages from initial biological soil crusts built up by green algae, to more developed soil crusts with mosses, as well as moss-soil lichen crusts, were classified. The spatial-temporal dynamics during the development resulted in a moss-lichens cover with discrete patches of pioneer organisms like green algae in between. At the study sites, 13 species of terricolous lichens were identified. The formation of the biological soil crust is important for the accumulation of soil organic matter in the first millimeters of the topsoil of these pioneer ecosystems. A correlation between cryptogamic biomass and soil carbon content were found.
In a recultivation area located in Brandenburg, Germany, five types of biocrusts (initial BSC1, developed BSC2 and BSC3, mosses, lichens) and non-crusted mineral substrate were sampled on tertiary sand deposited in 1985- 1986 to investigate hydrologic interactions between crust patches. Crust biomass was lowest in the non-crusted substrate, increased to the initial BSC1 and peaked in the developed BSC2, BSC3, the lichens and the mosses. Water infiltration was highest on the substrate, and decreased to BSC2, BSC1 and BSC3. Non-metric multidimensional scaling revealed that the lichens and BSC3 were associated with water soluble nutrients and with pyrite weathering products, thus representing a high nutrient low hydraulic feedback mode. The mosses and BSC2 represented a low nutrient high hydraulic feedback mode. These feedback mechanisms were considered as synergic, consisting of run-off generating (low hydraulic) and run-on receiving (high hydraulic) BSC patches. Three scenarios for BSC succession were proposed. (1) Initial BSCs sealed the surface until they reached a successional stage (represented by BSC1) from which the development into either of the feedback modes was triggered, (2) initial heterogeneities of the mineral substrate controlled the development of the feedback mode, and (3) complex interactions between lichens and mosses occurred at later stages of system development.
Iron-cyanide (Fe-CN) complexes have been detected at Manufactured Gas Plant sites (MGP) worldwide. The risk of groundwater contamination depends mainly on the dissolution of ferric ferrocyanide. In order to design effective reme- diation strategies, it is relevant to understand the contaminant’s fate and transport in soil, and to quantify and mathe- matically model a release rate. The release of iron-cyanide complexes from four contaminated soils, originating from the former MGP in Cottbus, has been studied by using a column experiment. Results indicated that long-term cyanide (CN) release is governed by two phases: one readily dissolved and one strongly fixed. Different isotherm and kinetic equations were used to investigate the driving mechanisms for the ferric ferrocyanide release. Applying the isotherm equations assumed an approach by which two phases were separate in time, whereas the multiple first order equation considered simultaneous occurrence of both cyanide pools. Results indicated varying CN release rates according to the phase and soil. According to isotherm and kinetic models, the long-term iron cyanide release from the MGP soils is a complex phenomenon driven by various mechanisms parallely involving desorption, diffusion and transport processes. Phase I (rapid release) is presumably mainly constrained by the transport process of readily dissolved iron-cyanide complexes combined with desorption of CN bound to reactive heterogeneous surfaces that are in direct contact with the aqueous phase (outer-sphere complexation). Phase II (limited rate) is presumably driven by the diffusion controlled processes involving dissolution of precipitated ferric ferrocyanide from the mineral or inner-sphere complexation of fer- ricyanides. CN release rates in phase I and II were mainly influenced by the pH, organic matter (OM) and the total CN content. The cyanide release rates increased with increasing pH, decreased with low initial CN concentration and were retarded by the increase in OM content.
Organic matter from biological soil crusts induces the initial formation of sandy temperate soils
(2014)
Different development stages of algae-dominated and moss-dominated biological soil crusts (BSCs) were sampled on a natural sand dune (b17 years old) and on an experimental sand dune (b8 years old) along a catena, including gradients of vegetation cover, location on the slope, as well as composition and thickness of BSC organisms in northeastern Germany. The accumulation of BSC-derived organic carbon (OC)was determined for bulk materials and fractions less than 63 μm. The OC composition was characterized by solid-state 13C NMR spectroscopy and the carbohydrate-C signature. 14C contents were determined to assess the origin and dynamics of OC. From the radiocarbon contents, two OC pools were differentiated: recent BSC-derived and lignite-derived “old” OC. Downward movement of OC into the underlying substratewas found only undermoss-dominated BSCs at the old sand dune. BSC-derived OC was mainly composed of carbohydrate-C and, to a lesser extent, alkyl C and N-alkyl C, with considerably higher contributions of alkyl C in the young dune, indicating differences in the composition of extracellular polymeric substances produced by the BSCs with age. This is consistent with higher proportions of water-soluble OC of moss-dominated BSCs at the old dune, which is leached in the underlying substrate and initiates soil formation. Because of the channeling effect of mosses, OC depth translocation along with suspended colloidal substances contribute to OC accumulation in substrates.
Cross-linked polyacrylates in post-mining substrates: persistence and effects on plant growth
(2014)
Application of hydrophilic polymers composed of cross-linked polyacrylate can improve soil water-holding capacity and accelerate the restoration of post-mining substrates. In this work, we studied the persistence of a polyacrylate polymer incorporated into a soil and its impact on plant nutrients at a reclamation site of former lignite mining in Lusatia (Germany). In contrast to autumn application, the incorporation of the polymer enhanced the sequestration of plant-derived carbon in the soil, which was reflected by a significant increase in the concentration of a lignin marker. Attenuated total reflexion–Fourier transform infrared spectra (ATR-FTIR) and total elemental contents in the applied polymer suggested an intensive cation exchange between the polymer framework and the soil-forming substrate. In addition, there was an enrichment of carbonaceous material, which seems to reduce the swelling and thus the water-holding capacity of the cross-linked polyacrylate. Conversely, this process protected the polymer structure from rapid decomposition.
The influence of biological soil crusts in natural ecosystems on structures and processes is well investigated. However, in South-Brandenburg (Germany), it is possible to study the development of biological soil crusts (BSC) during initial ecosystem genesis on two artificial water catchments with well-known ages and under differing starting conditions. The two experimental sites are located in the recultivation area of the lignite open-cast mining district of southern Brandenburg with a distance of approximately 1 km between them. Two different topographies were constructed at the experimental sites: the experimental plot at the catchment Neuer Lugteich was shaped like a dune, whereas the artificial water catchment Hühnerwasser was modelled as an inclined slope. The catchment Neuer Lugteich is four years older than Hühnerwasser. The original substrate at Neuer Lugteich is more sandy and carbonate-free compared to the original substrate dumped at Hühnerwasser. At both sites geomorphological differentiation and crust development were compared and the importance of substrate-dependent water availability and crust type clarified. Once settled, the crusts influenced the water regime of the soils by delaying infiltration through enhanced water repellency, and by limiting water infiltration. Chlorophyll analysis revealed that all crusts were at early stages of development. At Neuer Lugteich, the establishment of the biological soil crusts was closely associated with the vegetation succession, whereas no clear succession of the crusts could be observed at Hühnerwasser. The mosaic-like pattern of the biological soils crusts is associated with the distribution of fine-grained material here.zeige weniger
Vicinities of manufactured gas plants were often contaminated with solid iron–cyanide complexes
as a result of the coal gasification process. During the remediation of affected soils, knowledge about contaminant concentrations is crucial, but laboratory methods are often expensive and time consuming. Rapid and non-destructive field methods for contaminant determination permit an analysis of large sample numbers and hence, facilitate identification of ‘hot spots’ of contamination. Diffuse near infrared reflectance spectroscopy has proven to be a reliable analytical tool in soil investigation. In order to determine the feasibility of a Polychromix Handheld Field Portable Near-Infrared Analyzer (FP NIR), various sample preparation methods were examined, including homogenizing, sieving, drying, and grinding. Partial least squares calibration models were developed to determine near infrared (NIR) spectral responses to the cyanide concentration in the soil samples. As a control, the contaminant concentration
was determined using conventional flow injection analysis. The experiments revealed that portable
near-infrared spectrometers could be a reliable device for detecting cyanide concentrations >2,400 mgkg−1 in the field and >1,750 mgkg−1 after sample preparation in the laboratory.We found that portable NIR spectrometry cannot replace traditional laboratory analyses due to high limits of detection, but that it could be used for identification of contamination ‘hot spots’.